Stainless Steel
Tank Head and Vessel Circles
Circles for dished heads in 304 / 316L / 2205 — diameters up to 3000 mm, thickness 2–20 mm.
2–20 mmThickness
Ø300–3000 mmWidth
Available Specifications
| Material Grades | Thickness | Width / Diameter | Standard |
|---|---|---|---|
| 304 · 316L · 2205 | 2–20 mm | Ø300–3000 mm | ASTM A240 / EN 10088-2 |
The ranges shown reflect our standard supply scope; custom sizes are produced to order. Thickness is nominal — tolerances per ASTM A480 / EN 10088-2.
Typical Applications
- Dished and flanged tank heads
- Pressure vessel closures
- Storage silo heads
Delivery and Inspection
- Diameter tolerance ±2 mm, roundness checked against a template
- Thickness measured at three points per piece
- Edge prepared for spinning or pressing on request
Need a quote or technical advice?
Send us the material grade, dimensions, quantity and destination port — we will reply within 24 hours with FOB / CIF pricing.
Typical applications
Below is where this material actually ends up — the specific parts, not just the industry. Compare it with your own service conditions, or send us the environment and we will advise.
- Vessel heads — blanks for elliptical and dished heads
- Tank ends — storage, fermentation and water tank end caps
- Large vessels — one-piece end plates in the 1–2 m range
Selection FAQ
- What does head stock require?
- Good ductility and uniform thickness tolerance — usually 304 / 316L. The material is subsequently spun or pressed, so negative thickness deviation must be held tighter than for ordinary sheet.
- Can you supply over-width?
- Beyond standard width it needs welding or a wider feedstock; send the head diameter and forming process for assessment.
Not sure which grade fits? Use the grade selector